Rubber sheet
Wide sheets of EPDM cover the roof with as few seams as possible.
Flat Roofing
Rubber Roof Installation Montville, NJ
A roofer in Montville can install a rubber roof by laying EPDM membrane in wide sheets over insulation and a cover board, bonding or fastening it down and sealing every seam with primer and tape, so the roof handles sun, cold and storms for decades. Call (862) 420-3039 to reach a local roofer.
Rubber roofing usually means EPDM, though some people use the term for any single-ply membrane. EPDM is sold in wide rolls, typically 45 or 60 mil thick, and it stretches and recovers as the roof moves through hot and cold seasons. That flexibility is why it suits so many homes.
The first decision is how the membrane is held down. The sheet can be glued to the substrate, fastened with plates at the seams or laid loose under a layer of stone. Residential roofs are most often fully adhered.
Thickness and color are the next choices. Thicker 60 mil membrane stands up better to foot traffic and hail. Black is standard and holds heat, while white reflects it. The transition to a steeper roof or a wall is planned with the same care, since that is where low roofs most often leak.
Depending on what the roofer finds, rubber roof installation in Montville, NJ can go hand in hand with rubber roof repair and flat roof installation.
Need rubber roof installation in Montville? Call (862) 420-3039 to reach a nearby roofing contractor.
Call nowThe process
How rubber roof installation works
Each layer is set up to give the membrane a smooth, solid base.
Check the base
The deck is repaired and checked for slope, ideally a quarter inch per foot toward drains or gutters. Old roofing is removed if the roof is being replaced.
Insulation
Insulation boards go down for energy savings and slope, topped by a smooth cover board. Slope can be built in at this stage.
Roll out the membrane
The EPDM is unrolled, positioned and left to relax so wrinkles flatten before any adhesive goes on. Laps are arranged so water flows over them.
Adhering
Bonding adhesive is rolled onto both the cover board and the underside of the rubber, then the sheet is folded back down and broomed smooth. Then the other half is done the same way. Air pockets left under the sheet can turn into blisters later, so the crew works the rubber flat from the center out.
Tape the laps
Primer and seam tape join the sheets, with T-joints covered by extra patches. Tape edges are finished with lap sealant.
Flash the details
Walls and curbs get membrane flashing held by termination bar, pipes get pre-molded boots and corners get uncured flashing. The top edge is sealed and covered. A final walk checks every seam with a probe before the job is closed out.
What is included
Parts of a new EPDM roof
Seam tape
Laps are joined with seam tape for a lasting bond.
Deck preparation
The base is cleared and checked before new layers go down.
Flashing
Every penetration and edge is sealed with materials made for EPDM.
Insulation
Insulation adds energy savings and slope and gives the adhesive a firm grip.
Related service
EPDM Roof Installation Montville, NJ
The quality of an EPDM installation shows up years later in the seams and edges. A flat, dry base, properly timed adhesive and carefully primed seams are what make EPDM last. Dry, mild days give the best bond. Some installers use water-based adhesive for the field of the roof and solvent-based adhesive at walls and curbs, where the grip has to be strongest.
A good Montville installer also plans for movement. Flashing at walls and curbs is secured with termination bar so the sheet cannot pull loose as it ages, and corners get flexible uncured flashing. Ask about edge securement before work starts.
Local help
Rubber Roof Installation Near Me
Rubber roofs in Montville are common on porches, garages, additions and flat sections of older homes. Across Montville and nearby towns like Lake Hiawatha, Towaco, Boonton and Pine Brook, EPDM handles storms, sun and cold well when it is installed with good seams and drainage, which is why the seams and flashing deserve careful attention.
Need rubber roof installation around Montville? Call (862) 420-3039 for a Montville roofer who serves the towns around it too.
Roofs in this climate
Cold winters bring snow, ice and a long stretch of freezing nights. Heat escaping from the attic melts snow on the upper roof, and the water refreezes at the colder eaves, building ice dams that push water up under the shingles. Strong coastal storms push rain into every weak spot at the flashing and valleys. That is why roof repair in Montville is busiest after a hard winter and before the next one.
Why call
Why fix it now
Drier ceilings
Small roof problems caught early usually stay small repairs.
Familiar with local homes
Local roofers see the same roofs and storm damage across Montville and nearby towns.
Straight answers
Ask your questions before you agree to anything.
Rubber Roof Installation questions
How long does a new rubber roof last?
Rubber roofs often last decades. Good seams, drainage and occasional checks make the difference. Patching EPDM is straightforward.
Can a rubber roof go over an existing roof?
A recover is possible only under certain conditions. The old roof must be a single dry layer, with a recover board over it. Otherwise, a tear-off is needed. A moisture check of the old roof settles the question before any work is planned.
How thick should a rubber roof be?
EPDM usually comes in 45 or 60 mil for homes. The thicker sheet holds up better to traffic and weather. Even thicker sheets are available for demanding roofs.
What is the difference between EPDM and TPO?
The two are different materials. EPDM uses taped seams and stays flexible in cold, and TPO uses welded seams and reflects heat. Each suits different roofs.
What color EPDM is best?
The choice depends on the climate and the space below. Black EPDM absorbs heat, which can help in cold climates, while white EPDM reflects sunlight and keeps the rooms below cooler. Ask about both options.
More questions? Call (862) 420-3039
Related services
Rubber Roof Repair
EPDM rubber roof repairs done with primer, cover tape and lap sealant made for rubber, never with tar or asphalt cement that ruins the rubber.
Learn moreFlat Roof Installation
Flat roof installation from the deck and tapered insulation up to the seams, flashing and edge metal, so water drains instead of ponding.
Learn moreTPO Roofing
Heat-welded TPO membrane for flat and low-slope roofs, with seams welded into one watertight sheet.
Learn moreFlat Roof Replacement
Full replacement of failing flat roofs, with a moisture survey deciding tear-off or recover, with tapered insulation where water used to sit.
Learn more
Looking for something else?
See all roofing servicesNeed rubber roof installation in Montville, NJ?
Call (862) 420-3039 to talk to a roofer serving Montville, NJ.