Roof flashing
Step, counter and kickout flashing plus new pipe boots seals the places where the roof meets something else.
Roof Replacement
Roof Installation Montville, NJ
Installing a roof in Montville comes down to doing each layer in order, from the metal edges and underlayment to the flashing and the final ridge, and most of what makes a roof last happens before the first shingle goes down. One call to (862) 420-3039 reaches a nearby roofing contractor.
When a fairly new roof leaks, the cause is usually how it was installed rather than what it was made of. Nails driven above the reinforced strip, flashing left out at a sidewall and short valleys are the kind of mistakes that show up within a few seasons. By the time they show up, the stain is already on the ceiling.
Choosing the material comes first. Most homes get dimensional asphalt shingles, but metal panels, stone coated steel, tile and slate are all options, and each has its own installation rules. The slope of the roof limits the options, because shingles need a minimum pitch and nearly flat sections need a membrane roof.
A Montville roofer will ask a handful of questions up front. Mention whether the old roof is coming off or this is new framing, what material you have in mind and any spots that have leaked before.
If the problem goes deeper than it first looked, a Montville roofer may also recommend roof replacement or shingle roof installation.
Looking for Montville roof installation? Call (862) 420-3039 and describe the problem to a roofer who works in Montville.
Call nowThe process
Steps in a roof installation
Here is the usual order for installing a shingle roof.
Check the sheathing
The roof deck must be clean, dry and solid, with any soft plywood or OSB replaced and loose boards renailed. Nails cannot hold in soft wood, so this step is never skipped.
Install the ice barrier
Metal drip edge is installed at the eaves first, then self-adhering ice barrier covers the eaves and valleys. Codes in colder areas often require the ice barrier to reach a set distance inside the exterior wall.
Cover the deck
Synthetic underlayment or felt covers the rest of the deck, lapped so each row sheds over the one below. Most crews now use synthetic underlayment, which holds up better to foot traffic and weather.
Install flashing
Each sidewall gets step flashing course by course, chimneys get step and counter flashing and vent pipes get new boots. Sealant is a backup, not the flashing itself.
Lay the shingles
Starter shingles seal the first course, and each shingle is nailed through the marked nail line, not above it. Correct nailing is what lets the roof stand up to wind.
Finish the ridge
A ridge vent is cut in along the peak and covered with ridge cap shingles, matched to the intake at the soffits. Balanced intake and exhaust keep the attic drier in winter and cooler in summer.
What is included
What a roof installation includes
Roof covering
Starter strip, field shingles and ridge caps, or the panels and trim for a metal roof with fasteners placed where they belong.
Ventilation
Ridge vents or other exhaust paired with soffit intake which protects the roofing and the decking.
Drip edge
Drip edge at the eaves and rakes keeps water off the fascia boards.
Underlayment
A full layer of underlayment plus ice barrier where water collects acts as the second layer of protection.
Related service
New Roof Installation Montville, NJ
A new roof installation can mean a roof on a stripped house, a roof on new framing or a roof on an addition tied into an existing one. Tie-ins between new and old roofs are a common leak point, so they need full ice barrier and careful flashing. Ask the roofer how the tie-in will be handled and whether any of the existing roof will be replaced to make it work.
Every roofing product comes with instructions that set the nail count, nail placement, minimum slope and vent requirements. Good questions for a Montville roofing contractor include nail count, underlayment type and the ventilation plan. Vague answers about the hidden layers are worth noticing.
Related service
Roof Overlay Montville, NJ
With an overlay, sometimes called a layover or recover, the new roofing goes on top of the existing shingles. It is only allowed on a roof with one existing layer that lies flat over a solid deck. It saves the labor of a tear-off and keeps the house closed during the job.
There are good reasons most roofers prefer a tear-off. Nobody can see or repair the decking, the old flashing tends to stay in place, the extra weight sits on the framing, and bumps in the old roof can telegraph through the new shingles. If an overlay is on the table, ask the roofer to confirm the layer count, replace the drip edge and flashing and explain what happens at the next replacement, when both layers must come off.
Local help
Roof Installation Near Me
Around Montville, roof installation work covers older houses getting their second or third roof and newer homes adding on. From Montville out to neighboring communities such as Lake Hiawatha, Towaco, Boonton and Pine Brook, roofers see plank decks and thin attic vents on older houses and complex rooflines with many valleys on newer ones, and a careful installation is what lets a new roof ride out years of weather.
Need roof installation around Montville? Call (862) 420-3039 for a Montville roofer who serves the towns around it too.
How the weather here affects roofs around Montville
Winters here are long and cold, with snow on the roof for weeks at a time and plenty of nights below freezing. Heat escaping from the attic melts snow on the upper roof, and the water refreezes at the colder eaves, which is how ice dams form and back water up under the shingles. Strong coastal storms push rain into every weak spot at the flashing and valleys. That is why roof repair in Montville is busiest after a hard winter and before the next one.
Why call
Why not wait
Less damage
Small roof problems caught early usually stay small repairs.
Roofers who know Montville
Local roofers see the same roofs and storm damage across Montville and nearby towns.
Straight answers
Ask your questions before you agree to anything.
Roof Installation questions
What type of roof should I install?
It comes down to pitch, budget, look and how long you want the roof to last. Asphalt is the common choice, while metal, tile and slate each make sense for certain homes. A roofer can walk through the options for your specific roof.
How long does it take to install a new roof?
For an average house, plan on one to three days. Larger, steeper or more cut-up roofs need more days.
Is a permit needed to install a new roof?
Permit rules are set locally, and many places require one. Ask who will apply for the permit and whether an inspection is required.
What should be installed under the shingles?
The layers under the roofing are the drip edge, ice and water shield and a full layer of underlayment. Starter strip, step and kickout flashing and new pipe boots are also part of a proper installation.
Can a roof be installed in cold weather?
Cold weather does not stop a roof installation, but it changes the routine. Shingles can crack when cold, and the sealant may not activate until warm weather, so hand sealing is common. The deck has to be dry and free of frost.
More questions? Call (862) 420-3039
Other services that may help
Roof Replacement
A complete new roof from the deck up when repairs no longer make sense, built to current code from the decking out.
Learn moreShingle Roof Installation
New shingle roofs built layer by layer on a sound deck, for new homes, additions and reroofs.
Learn moreMetal Roof Installation
New metal roofs in standing seam, exposed fastener, metal shingle and stone coated steel, so the roof handles heat, wind and thermal movement.
Learn moreNew Construction Roofing
Roofing for new homes, additions, garages and other new framing, from dry-in to the finished ridge, so the house is protected before interior work starts.
Learn more
Looking for something else?
See all roofing servicesGet roof installation help in Montville
Call (862) 420-3039 to talk to a roofer serving Montville, NJ.